Latest topics
» 2019 Event List update
Tue Mar 19, 2019 8:57 am by zorteus

» Old pre-mix.
Mon Mar 18, 2019 4:11 pm by kerabo

» Browser problems
Mon Mar 18, 2019 12:10 pm by zorteus

» shows old and new
Mon Mar 18, 2019 12:01 pm by zorteus

» Spare spring nut
Sun Mar 17, 2019 7:23 pm by mike Sayer

» 8e 197 g/box & clutch help
Sun Mar 17, 2019 5:14 pm by Mark9

» AMC piston rings wanted
Thu Mar 14, 2019 3:08 pm by piston 197

» cruiser 80 clutch adjusting screw ?
Thu Mar 14, 2019 10:37 am by kerabo

» Speedo cable
Wed Mar 13, 2019 8:18 am by FBKev


Help with gasket (gearbox)

Go down

Help with gasket (gearbox)

Post  Martinrhyl on Mon Oct 22, 2018 8:41 am

Hi ive just purchased a gasket set for my francis barnett light cruiser 79 172cc amc, i need to change the engine side case gaskets what i can do but i also need to change the gear box gasket after i take the side case off it looks like 3 screws if i take this off the gear lever goes into it,, is it an easy job or will gear box come apart :/ thanks anyone habe pictures i can go off thank you
Martinrhyl
Martinrhyl

Posts : 55
Join date : 2016-04-21
Age : 35
Location : Rhyl, north wales

Back to top Go down

Re: Help with gasket (gearbox)

Post  kerabo on Mon Oct 22, 2018 8:55 am

Use clear sealant . My 20T only has one gasket and that's the Head Gasket.  Use it carefully espically around the barrel ports.

My way anyway.

If you are a member pm me your email address and I will send you information on the side cover. There are O rings in the case for the kickstart and gear change and also for the gear change indicator
Ken
kerabo
kerabo

Posts : 2644
Join date : 2008-02-11
Age : 68
Location : Falcon 87..1936 Cruiser 39. Falcon 81 Green Lane bitsa. Sunbeam S8. Honda Deuville.

Back to top Go down

Re: Help with gasket (gearbox)

Post  Martinrhyl on Mon Oct 22, 2018 9:08 am

Hi ken thank pal yes i did replace the o rings last time and still leak :/ what clear selant would you recommend?will pm you now
Martinrhyl
Martinrhyl

Posts : 55
Join date : 2016-04-21
Age : 35
Location : Rhyl, north wales

Back to top Go down

Sealing covers

Post  kerabo on Mon Oct 22, 2018 10:36 am

You will find if you put your covers on a flat section production paper and start to rub them just how distorted they are. More than the thickness of a gasket.

Halfords do Locktite sealant and that's very good. You can get grey but not sure about clear. If you clean it off you don't notice it.

Don't over do it you only need a very thin line.

Regards Ken
kerabo
kerabo

Posts : 2644
Join date : 2008-02-11
Age : 68
Location : Falcon 87..1936 Cruiser 39. Falcon 81 Green Lane bitsa. Sunbeam S8. Honda Deuville.

Back to top Go down

Re: Help with gasket (gearbox)

Post  Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum