Latest topics
» 2t Villiers Electronic Ignition etc
Yesterday at 8:34 pm by stuart elkes

» Dating certificate
Yesterday at 3:53 pm by FBOVS429

» Cruiser 39 Dynamo
Sat Oct 20, 2018 3:10 pm by kerabo

» Cruiser piston rings needed please
Tue Oct 16, 2018 10:40 am by kerabo

» WIRING HARNESS WANTED
Tue Oct 16, 2018 10:38 am by kerabo

» Stafford Show
Mon Oct 15, 2018 6:39 pm by stuart elkes

» What's this?
Sun Oct 14, 2018 8:34 pm by piston 197

» head bolts 8e
Sun Oct 14, 2018 12:55 pm by alan67

» Copdock and Scotland
Sat Oct 13, 2018 7:21 am by alan67


Falcon 54, Bearings for headstock and Fork springs

Go down

Falcon 54, Bearings for headstock and Fork springs

Post  blackjak on Wed May 16, 2018 6:55 am

Can some one please advise me of the number and size of ball bearings (top and bottom) required for the headstock yoke for a Falcon 54. Also are there any tricks to lengthen one of the springs in the forks without having to buy new ones? I have 10mm difference in length. Neither springs are broken so I am thinking it is from the bike having been laying around for 30 odd years.

cheers
blackjak

blackjak

Posts : 37
Join date : 2013-10-08
Location : Perth Western Australia

Back to top Go down

bearings

Post  piston 197 on Wed May 16, 2018 7:44 am

J H Goddards book says 19 off 1/4" balls top and bottom ?

i do not think 10mm difference will matter much
JH
avatar
piston 197
Moderator

Posts : 4067
Join date : 2008-08-17
Location : ross-on-wye

Back to top Go down

Re: Falcon 54, Bearings for headstock and Fork springs

Post  blackjak on Wed May 16, 2018 8:48 am

Thanks John. Obviously I did not read my Goddards book thoroughly enough. As for the forks when I reassembled them there was a definite lean to the side. I will change the springs around and see if that makes any difference.

blackjak

blackjak

Posts : 37
Join date : 2013-10-08
Location : Perth Western Australia

Back to top Go down

Re: Falcon 54, Bearings for headstock and Fork springs

Post  Paul Preedy on Thu May 24, 2018 4:54 pm

Hi
I had a similar problem and found that where the print turns and locks into the bottom of the fork
There's a sort is worm and for the spring to screen into check there ? I had to take apart fix and reweld !!

Paul Preedy

Posts : 3
Join date : 2018-03-04

Back to top Go down

Re: Falcon 54, Bearings for headstock and Fork springs

Post  Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum