Latest topics
» Double lift centre stand
Yesterday at 8:07 pm by MoscowFlyer

» Falcon 54, Bearings for headstock and Fork springs
Yesterday at 4:54 pm by Paul Preedy

» 1954 falcon rear wheel?
Yesterday at 3:34 pm by Paul Preedy

» Registration After May 2018
Yesterday at 12:26 pm by peter@dunfordconstruction

» Members general well being
Yesterday at 12:08 pm by mike Sayer

» Frame number
Wed May 23, 2018 5:16 pm by wildtone2001

» Falcon 67 brakes
Wed May 23, 2018 9:44 am by TonyC

» Parts needed for 1954 Falcon
Mon May 21, 2018 12:59 pm by MoscowFlyer

» Crank shaft bearing
Sun May 20, 2018 11:19 am by Chick1


Model 96 parts

Go down

Model 96 parts

Post  dalgrae on Mon May 14, 2018 3:32 pm

Hi can someone pleas advise me regarding the gear change and kickstart rubbers for a Model 96 are they the same as the Norton Dominator / AMC models or are they unique to the 96

Regards. Colin

dalgrae

Posts : 56
Join date : 2017-04-08
Age : 68
Location : Bristol

Back to top Go down

rubbers

Post  piston 197 on Mon May 14, 2018 5:57 pm

Yes they are the same, although most repro ones are very poor quality synthetic rubber, i have had the AMC kick start rubbers made in a proper rubber, as they were originally, they are 4.75p inc postage, but i do not have the gearchange ones.
The ones i have made for the Kickstart are not available anywhere else, i own the mould and have them made properly by V Gardener rubber in the Forest of Dean, ( not India!) the same guy who does the tank badge rubbers, seat bungs, filler cap seals and horn surrounds for me.

JH
avatar
piston 197
Moderator

Posts : 3888
Join date : 2008-08-17
Location : ross-on-wye

Back to top Go down

Model 96 parts

Post  dalgrae on Tue May 15, 2018 6:57 am

Hi John thanks for this ,cheque is in the post

Regards. Colin

dalgrae

Posts : 56
Join date : 2017-04-08
Age : 68
Location : Bristol

Back to top Go down

Re: Model 96 parts

Post  dalgrae on Fri May 18, 2018 2:29 pm

Hi thanks John great service and superb quality just the gear lever rubber left to buy.

Regards. Colin

dalgrae

Posts : 56
Join date : 2017-04-08
Age : 68
Location : Bristol

Back to top Go down

Fitting

Post  piston 197 on Fri May 18, 2018 2:37 pm

Colin to fit just put a little petrol inside the hole, tip the excess out, then push onto kick start, they used the same rubber on Norton Commando and Matchless /AJS 650's .I recently sold a second one at Ross autojumble to a Commando owner who bought one off me 3 years ago after having had 3 others purchased by him split in a month previously.
I asked whether this one had given up the ghost after 3 years, he said no it was still as good as new, he was buying one for a friend who was having the same problems he had !
JH
avatar
piston 197
Moderator

Posts : 3888
Join date : 2008-08-17
Location : ross-on-wye

Back to top Go down

Re: Model 96 parts

Post  Sponsored content


Sponsored content


Back to top Go down

Back to top


 
Permissions in this forum:
You cannot reply to topics in this forum