Latest topics
» Cruiser 39 wiring.
Yesterday at 3:59 pm by kerabo

» 1935 Francis Barnett cruiser
Yesterday at 2:03 pm by davin999

» Villiers 32A
Yesterday at 11:19 am by peter@dunfordconstruction

» Tank cleaning
Yesterday at 6:27 am by kerabo

» Help with gasket (gearbox)
Mon Oct 22, 2018 10:36 am by kerabo

» VILLIERS 1H
Mon Oct 22, 2018 9:44 am by FBKev

» 2t Villiers Electronic Ignition etc
Sun Oct 21, 2018 8:34 pm by stuart elkes

» Dating certificate
Sun Oct 21, 2018 3:53 pm by FBOVS429

» Cruiser 39 Dynamo
Sat Oct 20, 2018 3:10 pm by kerabo


Ignition coil

Go down

Ignition coil

Post  Grahamb on Sat Mar 31, 2018 1:21 pm

Hi All

Purchased a new ignition coil a while ago and today had a look on how to fit it.

(the bike was converted to run with a 6v HT coil off the battery)

The new ignition coil has a very small terminal on one edge to connect the primary wire to.
I tried soldering a wire to this but it would not take .

Can anyone tell me the correct way of connecting  this wire please.



Regards Graham


Last edited by Grahamb on Sat Mar 31, 2018 1:39 pm; edited 1 time in total
avatar
Grahamb

Posts : 25
Join date : 2016-11-06
Age : 66
Location : Carbrooke Norfolk

Back to top Go down

connecting

Post  piston 197 on Sat Mar 31, 2018 1:33 pm

No soldering is the correct way you possibly need a bigger iron, i am assuming you have tinned the wire with flux and solder first ?
JH


Last edited by piston 197 on Sat Mar 31, 2018 1:43 pm; edited 1 time in total
avatar
piston 197
Moderator

Posts : 4067
Join date : 2008-08-17
Location : ross-on-wye

Back to top Go down

wiring coil

Post  Grahamb on Sat Mar 31, 2018 1:38 pm

Thanks JH

Now soldered, had to use some plumbers acid flux
avatar
Grahamb

Posts : 25
Join date : 2016-11-06
Age : 66
Location : Carbrooke Norfolk

Back to top Go down

Re: Ignition coil

Post  Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum