Latest topics
» 1934 Cruiser automatic lubrication
Today at 3:16 pm by fulmar88

» Found this
Yesterday at 11:41 am by kerabo

» Albion 4 speed box
Fri Apr 20, 2018 6:25 pm by Cyclethread

» Cleaning inside petrol tank
Fri Apr 20, 2018 3:37 pm by peter@dunfordconstruction

» cruiser 80 headlamp
Fri Apr 20, 2018 12:21 pm by intrudin

» Cruiser front wheel spacing.
Fri Apr 20, 2018 8:25 am by rob spence

» Bridge frame engine plates
Thu Apr 19, 2018 5:30 pm by keith.hodgenia

» Villiers carburettor main jet/centrepiece codes
Thu Apr 19, 2018 5:10 pm by MoscowFlyer

» Albion 4 Speed Gearbox
Thu Apr 19, 2018 3:50 pm by Maurice


Ring gap on a 16A

Go down

Ring gap on a 16A

Post  lushey1 on Wed Mar 21, 2018 4:21 am

Currently working on a Villiers 16A.With a ring in the bore,the gap is .047.Seems excessive but I have no reference.If so, should I go for a rebore, new piston and rings?

lushey1

Posts : 3
Join date : 2018-02-16

Back to top Go down

ring gap

Post  piston 197 on Wed Mar 21, 2018 6:51 am

The recommended is .003" per inch of bore ( MINIMUM), but with a two stroke this may also have to include the peg, so for instance if your piston has the slash cut rings with a diagonal brass peg you will have to add the width of the peg, if it is the square peg which is only half of the ring width you can ignore it and just go by the ring end gap.
JH
avatar
piston 197
Moderator

Posts : 3851
Join date : 2008-08-17
Location : ross-on-wye

Back to top Go down

Back to top


 
Permissions in this forum:
You cannot reply to topics in this forum