Latest topics
» Off-set when building rear wheel.
Today at 10:14 am by trophy

» Cruiser 39 Gearbox
Yesterday at 4:36 pm by kerabo

» Off-set when building rear wheel.
Wed Feb 20, 2019 7:43 pm by trophy

» Rigid frame rear stand.
Wed Feb 20, 2019 7:16 pm by woodenhead

» CRUISER 80 FOR SALE
Tue Feb 19, 2019 10:32 pm by MR SINBAD

» Clutch Corks
Mon Feb 18, 2019 7:38 pm by kerabo

» 1938 wanderer werke. Villiers
Mon Feb 18, 2019 2:42 pm by Turbojim

» engine id
Mon Feb 18, 2019 1:53 pm by intrudin

» Gearbox help
Sun Feb 17, 2019 3:19 pm by Archie Howard


Clutch bolts Plover 147cc 30c

Go down

Clutch bolts Plover 147cc 30c

Post  bill2b on Mon Oct 30, 2017 10:25 am

Hi folks the rebuild is going well, have new Bonded clutch plates from Villiers, just fitting the 6bolts and springs but cannot find anything about how tight to do them up, any ideas?
Cheers
Bill
bill2b
bill2b

Posts : 101
Join date : 2017-09-26

Back to top Go down

Clutch adjustment

Post  piston 197 on Mon Oct 30, 2017 12:43 pm

The screws should go fully in and be tightened, this may cause the clutch to drag, if the plates have been corked with thick corks !, but better than leaving them loose as they will work out and form a gouge or deep radial groove in the inner chaincase or worse !
Best to use automatic gearbox fluid in the clutch case ( TQF/ATF)
JH
piston 197
piston 197
Moderator

Posts : 4256
Join date : 2008-08-17
Location : ross-on-wye

Back to top Go down

Re: Clutch bolts Plover 147cc 30c

Post  bill2b on Mon Oct 30, 2017 1:01 pm

Thanks John, the plates are bonded not corked so will the same apply re the tightening and tqf? Ta
bill2b
bill2b

Posts : 101
Join date : 2017-09-26

Back to top Go down

clutch

Post  piston 197 on Mon Oct 30, 2017 1:22 pm

Yes screws have to be fully home and locked or they will gradually work themselves out and hit the inner case, TQF is fine with bonded plates, it is the set up I always ran on my Villiers engine trials bikes and they get a lot more stick than you are going to do .
JH
piston 197
piston 197
Moderator

Posts : 4256
Join date : 2008-08-17
Location : ross-on-wye

Back to top Go down

Re: Clutch bolts Plover 147cc 30c

Post  bill2b on Mon Oct 30, 2017 1:53 pm

Thanks John, gteat help as usual.
bill2b
bill2b

Posts : 101
Join date : 2017-09-26

Back to top Go down

Re: Clutch bolts Plover 147cc 30c

Post  Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum