Latest topics
» Battery Help
Today at 2:07 pm by FBKev

» Yorkshire police Falcon
Yesterday at 1:02 pm by piston 197

» Cruiser oil
Mon Jan 21, 2019 6:48 pm by kerabo

» One from every year
Mon Jan 21, 2019 8:12 am by piston 197

» Speedo drive - Rear wheel
Sun Jan 20, 2019 5:32 pm by piston 197

» American thoughts of a British Bike Cruiser 39.
Sun Jan 20, 2019 5:10 pm by John Wakefield

» NEW CLUB MEMBERS
Sun Jan 20, 2019 10:40 am by piston 197

» Cruiser 39 gear change
Sat Jan 19, 2019 5:16 pm by kerabo

» Re-register Cruiser/Falcon
Sat Jan 19, 2019 1:08 pm by peter@dunfordconstruction


Wiring for AMC trials

Page 2 of 2 Previous  1, 2

Go down

Re: Wiring for AMC trials

Post  woodenhead on Fri Sep 29, 2017 7:21 pm

Hi
In case your thinking you can use your original coils they will not do what the completion coils will do.
They are specifically designed to do the ignition only and the other coils are for lighting.
To check the coils check resistance to make sure there is no open circuit and then if you put a volt meter accros the coil and kick the engine over you should see some movement on the needle.
Regards
Mike d.
woodenhead
woodenhead

Posts : 261
Join date : 2008-09-08
Age : 76
Location : Berks.

Back to top Go down

Re: Wiring for AMC trials

Post  rob spence on Sat Sep 30, 2017 3:53 pm

Thanks, I just want to test them at this stage before I decide which way to go for ignition...I'm favouring electronic at the moment.

rob spence

Posts : 175
Join date : 2017-03-20

Back to top Go down

Page 2 of 2 Previous  1, 2

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum