Latest topics
» 6e carburettor
Today at 4:41 pm by piston 197

» Hello - new owner 1958 Crusier 2T, bike registration help, photo added
Today at 1:48 pm by chrisbwy

»  Plover won't start -:no spark
Yesterday at 4:59 pm by piston 197

» Are these Francis Barnett
Yesterday at 7:42 am by kerabo

» Cruiser 80
Sun Nov 18, 2018 8:58 pm by intrudin

» Anyone have one of these?
Sat Nov 17, 2018 2:49 pm by kerabo

» cruiser 45 carburettor
Sat Nov 17, 2018 7:34 am by piston 197

» Buckled flywheel
Fri Nov 16, 2018 7:41 pm by piston 197

» May help someone Handelbars
Fri Nov 16, 2018 7:39 am by kerabo


2t crankshaft

Go down

2t crankshaft

Post  plugcap on Tue Jul 08, 2014 4:57 pm

Hi
How do you get to the center bearing on this crank it feels quite rough and in need of replacing, can it be split, I would be gratefull if i could obtain a engine parts list and manual for this engine.

plugcap

Posts : 37
Join date : 2013-10-16

Back to top Go down

manual

Post  kerabo on Tue Jul 08, 2014 5:50 pm

[u[/u
I have a used 2T 3T manual.looks like an original.  Bought it at a VMCC sale and won't need it . If you don't get sorted let me know.
I have never replaced the crank on these but am pretty sure the middle main is a specialist job
Regards Ken
avatar
kerabo

Posts : 2497
Join date : 2008-02-11
Age : 68
Location : Falcon 87..1936 Cruiser 39. Falcon 81 Green Lane bitsa. Sunbeam S8. Honda Deuville.

Back to top Go down

centre seal

Post  piston 197 on Tue Jul 08, 2014 6:35 pm

Have done it twice myself , with full engineering kit, truing jig, presses etc after the first time I thought I am not doing that again!, but after time eased the pain , did it a second time and it all came back !
You have to split one big-end, before you can part the centre webs, then you have to true it all up again , having pressed both the centre webs, and the big-end you split, back up to the original widths, Suggest you send the whole assembly to Nametab engineering, he will even do an exchange service 01527 522266 and then all big-ends, centre seal , outside seals and small ends are re-done JH
avatar
piston 197
Moderator

Posts : 4116
Join date : 2008-08-17
Location : ross-on-wye

Back to top Go down

2t crankshaft

Post  plugcap on Wed Jul 09, 2014 8:42 am

Thanks for your advice , I think the best way is nametab saves me useing my hammer and chisel.
RJ

plugcap

Posts : 37
Join date : 2013-10-16

Back to top Go down

Re: 2t crankshaft

Post  Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum