Latest topics
» Off-set when building rear wheel.
Today at 10:14 am by trophy

» Cruiser 39 Gearbox
Yesterday at 4:36 pm by kerabo

» Off-set when building rear wheel.
Wed Feb 20, 2019 7:43 pm by trophy

» Rigid frame rear stand.
Wed Feb 20, 2019 7:16 pm by woodenhead

» CRUISER 80 FOR SALE
Tue Feb 19, 2019 10:32 pm by MR SINBAD

» Clutch Corks
Mon Feb 18, 2019 7:38 pm by kerabo

» 1938 wanderer werke. Villiers
Mon Feb 18, 2019 2:42 pm by Turbojim

» engine id
Mon Feb 18, 2019 1:53 pm by intrudin

» Gearbox help
Sun Feb 17, 2019 3:19 pm by Archie Howard


rectifier position

Go down

rectifier position

Post  banjo boy on Mon Mar 24, 2014 9:05 pm



This is where the rectifier was fitted before I stripped the bike down for a cosmetic make over can any one tell me if this is where it should be or is this about right the bracket is a home made job from the looks of it,thanks Very Happy 

banjo boy
banjo boy
banjo boy

Posts : 249
Join date : 2013-10-22
Age : 54
Location : cambridgeshire

Back to top Go down

rectifier position

Post  top brass on Tue Mar 25, 2014 10:13 am

Should be bolted to the green panel behind it sling the old lump that`s holding it on

Tony W  Smile 
top brass
top brass

Posts : 145
Join date : 2012-09-29
Age : 78
Location : bolton lancs.

Back to top Go down

Re: rectifier position

Post  banjo boy on Tue Mar 25, 2014 1:08 pm

Thanks Tony for your info I will put it where you said when I assemble the tool box part thanks again Cool 

Laurence
banjo boy
banjo boy

Posts : 249
Join date : 2013-10-22
Age : 54
Location : cambridgeshire

Back to top Go down

Falcon 87 rectifier

Post  FB vincent on Tue Mar 25, 2014 2:49 pm

banjo boy wrote:

This is where the rectifier was fitted before I stripped the bike down for a cosmetic make over can any one tell me if this is where it should be or is this about right the bracket is a home made job from the looks of it,thanks Very Happy 

banjo boy
 
The original Wipac selenium rectifier was dish shaped and attached horiziontally by the vertical stud from the top frame. A modern rectifier is much smaller and can be fitted to the cross plate between the two toolboxes, the tinwork providing a heat sink. The photo below shows both original and replacement rectifiers on my Falcon 87. Sandy Ross
 

FB vincent

Posts : 673
Join date : 2009-01-20
Location : Hertfordshire

Back to top Go down

Re: rectifier position

Post  banjo boy on Tue Mar 25, 2014 5:54 pm

Thank you Sandy for the picture,that would explain why the long stud under the cross frame ,that's a neat job you did with the replacement rectifier thanks again for your help

Laurence Cool 
banjo boy
banjo boy

Posts : 249
Join date : 2013-10-22
Age : 54
Location : cambridgeshire

Back to top Go down

Re: rectifier position

Post  Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum