Latest topics
» Restoration
Today at 4:49 pm by Dave caffrey

» Registering a James for the first time...
Yesterday at 7:21 pm by piston 197

» Off-set when building rear wheel.
Yesterday at 10:14 am by trophy

» Cruiser 39 Gearbox
Thu Feb 21, 2019 4:36 pm by kerabo

» Off-set when building rear wheel.
Wed Feb 20, 2019 7:43 pm by trophy

» Rigid frame rear stand.
Wed Feb 20, 2019 7:16 pm by woodenhead

Tue Feb 19, 2019 10:32 pm by MR SINBAD

» Clutch Corks
Mon Feb 18, 2019 7:38 pm by kerabo

» 1938 wanderer werke. Villiers
Mon Feb 18, 2019 2:42 pm by Turbojim


Go down


Post  sunbeam 90 on Mon Aug 22, 2011 10:57 pm

Information needed for a AMC 150 cc 1961 plover magneto flywheel. Can any one tell me the diameter and pitch and form of thread for the flywheel puller needed for this engine. Also what size and thread is the nut that holds the flywheel on.Thanks Dave. PS, I think the nut is a left hand thread but at the moment it is just turning in both directions on the crankshaft and i need to work out how to remove it without causing any damage to the crankshaft and with a bit of luck the crank being harder steel than the nut, most of the striping/wear will be on the nut.

sunbeam 90

Posts : 2
Join date : 2011-08-22

Back to top Go down

Back to top

- Similar topics

Permissions in this forum:
You cannot reply to topics in this forum